-40%
For 1997-1998 Ford Explorer V8 5.0L V6 4.0L Mercury Mountaineer 5.0L Fuel Pump
$ 29.03
- Description
- Size Guide
Description
The Function of the fuel pump is to supply fuel at a certain pressure to the engine fuel injection system.However,the fuel pump have a limited life.If you notice any of the following signs with your car:
(1).Engine Sputtering at High Speeds
(2).Decreased Fuel Pressure
(3).Losing Power when the Vehicle is under Stress
(4).Inability to accelerate
(5).Decreasing Gas Mileage
(6).Engine Not Starting
This may indicate that you need to replace the fuel pump
Fuel Pump Replacement Guideline:
Please Note the following before replacing the fuel pump:
1.Ensure that you are in a well ventilated and level work area.
For 1997-1998 Ford Explorer V8 5.0L V6 4.0L Mercury Mountaineer 5.0L Fuel Pump
The Function of the fuel pump
is to supply fuel at a certain pressure to the engine fuel injection system.
However,the fuel pump have a limited life.If you notice any of the following
signs
with your car:
(1).Engine Sputtering at High Speeds
(2).Decreased Fuel Pressure
(3).Losing Power when the Vehicle is under Stress
(4).Inability to accelerate
(5).Decreasing Gas Mileage
(6).Engine Not Starting
This may indicate that you need to replace the fuel pump
Fuel Pump Replacement Guideline
:
Please Note
the following before replacing the fuel pump:
1.Ensure that you are in a well ventilated and level work area.
2.Use approved safety glasses or goggles when working on any motor vehicle.
3.The gasoline is sucked out of the tank and stored in a container dedicated to gasoline.
Picture(A)
Disconnect the ground (
negative
) cable of the battery and ensure that it does not accidentally spark while working.
Picture(
B
)
Locate and remove gas tank filler neck mounting bolts or remove the filler tube from the tank. This will aid the fuel removal especially if you had problems accessing through the filler neck.
Picture(
C
)
Located the electrical connector for the fuel pump and fuel level sender which will be in the same wiring harness. If access if difficult or you can't see them wait until the tank is lowered slightly to undo the connector. Inspect electrical connector for burns or heated spots and replace if damaged. A burned connector can cause a pump to fail intermittently.
Picture(
D
)
There will be fuel vapor lines as part of the EVAP system these will need to be removed or disconnected.
Picture(
E
)
Locate and release tank holder supports, there are two in most cases. Remove the mounting bolts at this point the tank will become loose but may not come out.
Picture(
F
)
Lower the tank and release top mounted fuel lines or electrical connectors if any. Continue to remove the tank.
Picture(
G
)
Remove the tank, this will expose the fuel pump retainer ring. Use an aerosol cleaner to remove dirt and debris from the area. This will keep the inside of the fuel tank clean when performing the repair.
Picture(
H
)
Remove fuel pump mounting bolts or retainer ring to access the fuel pump module and remove the unit. Use a hammer and punch to remove the ring counterclockwise.
Picture(
I
)
Remove the fuel pump which will be attached to the mounting plate or positioned down inside the tank held by plastic retainer clips.
Picture(
J
)
Remove the fuel pump from the tank.
We only accept payment through PayPal.
Shipping
All domestic orders will be shipped via USPS, UPS or Fedex from our US warehouse and usually arrives to your door in about 2-7 business days.
Returns
All of our brand new items come with a 60-Days money-back guarantee.
Contact Us
Any question, please contact us by email on working days.
Warning
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
Best Sales
For Pontiac G6 Chevy Malibu 2.4L 3.5L 3.6L 3.9L Saturn Aura 2.4L 3.5L Fuel Pump
USD 72.49
For 2003 2004 Ford Expedition V8 5.4L Fuel Pump E2360M
USD 47.49
For 2004 2005 2006 2007 2008 Ford F-150 4.6L 5.4L Fuel Pump E2434M
USD 57.49
For Chevy C1500 C2500 C3500 K1500 K2500 K3500 GMC C1500 C2500 C3500 Fuel Pump
USD 54.74
For Dodge Ram 1500 2500 5.2L 5.9L 1996-1997 Fuel Pump w/Sending Unit E7093M
USD 64.99
Newly Listed
Fuel Pump Fit For Chevrolet Suburban 1996 1997 HP10003 SP123A1H
USD 63.99
Fuel Pump Fit For Ford Ranger L4 2.5L 2001 HP10230 SP2269H E2269S
USD 59.99
Fuel Pump Fit For Chevrolet Equinox Pontiac Torrent V6 3.4L 3.6L
USD 105.99
Fuel Pump Fit For Jeep Commander V8 4.7L 2007 2008 2009 2010
USD 61.99
Fuel Pump Fit For Ranger L4 2.3L 1985 1986 1987 1988 HP10166
USD 56.99
Terms & Contact
Payment Policy
Shipping Policy
Return Policy
FAQ
About Us
For 1997-1998 Ford Explorer V8 5.0L V6 4.0L Mercury Mountaineer 5.0L Fuel Pump
The Function of the fuel pump
is to supply fuel at a certain pressure to the engine fuel injection system.
However,the fuel pump have a limited life.If you notice any of the following
signs
with your car:
(1).Engine Sputtering at High Speeds
(2).Decreased Fuel Pressure
(3).Losing Power when the Vehicle is under Stress
(4).Inability to accelerate
(5).Decreasing Gas Mileage
(6).Engine Not Starting
This may indicate that you need to replace the fuel pump
Fuel Pump Replacement Guideline
:
Please Note
the following before replacing the fuel pump:
1.Ensure that you are in a well ventilated and level work area.
2.Use approved safety glasses or goggles when working on any motor vehicle.
3.The gasoline is sucked out of the tank and stored in a container dedicated to gasoline.
Picture(A)
Disconnect the ground (
negative
) cable of the battery and ensure that it does not accidentally spark while working.
Picture(
B
)
Locate and remove gas tank filler neck mounting bolts or remove the filler tube from the tank. This will aid the fuel removal especially if you had problems accessing through the filler neck.
Picture(
C
)
Located the electrical connector for the fuel pump and fuel level sender which will be in the same wiring harness. If access if difficult or you can't see them wait until the tank is lowered slightly to undo the connector. Inspect electrical connector for burns or heated spots and replace if damaged. A burned connector can cause a pump to fail intermittently.
Picture(
D
)
There will be fuel vapor lines as part of the EVAP system these will need to be removed or disconnected.
Picture(
E
)
Locate and release tank holder supports, there are two in most cases. Remove the mounting bolts at this point the tank will become loose but may not come out.
Picture(
F
)
Lower the tank and release top mounted fuel lines or electrical connectors if any. Continue to remove the tank.
Picture(
G
)
Remove the tank, this will expose the fuel pump retainer ring. Use an aerosol cleaner to remove dirt and debris from the area. This will keep the inside of the fuel tank clean when performing the repair.
Picture(
H
)
Remove fuel pump mounting bolts or retainer ring to access the fuel pump module and remove the unit. Use a hammer and punch to remove the ring counterclockwise.
Picture(
I
)
Remove the fuel pump which will be attached to the mounting plate or positioned down inside the tank held by plastic retainer clips.
Picture(
J
)
Remove the fuel pump from the tank.
Payment
Shipping
Returns
Contact Us
Warning
We only accept payment through PayPal.
All domestic orders will be shipped via USPS, UPS or Fedex from our US warehouse and usually arrives to your door in about 2-7 business days.
All of our brand new items come with a 60-Days money-back guarantee.
Any question, please contact us by email on working days.
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
All rights reserved.